Creative articles about sewing

V-neck T-shirt: tutorial

V-neck T-shirt: tutorial

Do you want to adapt a sewing pattern for a round-neck T-shirt to a V-neck or just want to see in detail how to sew a V-neck?
In this tutorial I will show you how to do this easily and how to finish the V-neck with a matching neckband.
With clear steps and practical tips you’ll effortlessly make the switch from round to V 😉

Requirements

-t-shirt pattern
-sewing machine
-overlocker
-matching thread

Tutorial

1.Adjusting the pattern and draw neckband pattern piece

You can skip this step if you are already working with a V-neck pattern.

Take your front bodice pattern piece and hold it in front of you.
Indicate how deep you would like the V-neck to be.

Draw the V-neck onto your pattern piece and cut out.

Measure your V-neck and the neckline of the back together.
Take 85% of the circumference if you are working with the t-shirt fabric itself, 75% if you are working with ribbing, and don’t forget your seam allowance.
That will be the width of your pattern piece.
As the height, take 5 to 6cm for a finished neckband of 1.5 to 2cm high.

Draw your rectangle to the correct dimensions:

Draw on 1 side (not at the fabric fold) about 2cm inward of the pattern piece.


Draw the V for your neckband:

Ready to cut out your pattern pieces!

2. Front and back neckline notches

Indicate center back neckline with a small clip within the seam allowance.

Merkteken middenachter

Draw the seam allowance of your V-neck onto the front pattern piece (at the wrong side of the fabric).

Aanduiding V-hals voorpand

3. Preparing and attaching the neckband

Indicate the center of the neckband with small clips.

Halsboord voorbereiden

Fold neckband in half, right sides facing and pin.

Stitch seam.
Clip the V until right before your stitches.

Press seam open.

Naad halsboord openstrijken

Fold and press in half again, wrong sides facing.
This way you’ll get a tunnel.
Cut off excess pieces of fabric.

Mark the notch for the V-neckline:
To do this, draw lines at the back of your neckband 1cm from the edge to where they intersect in the V.

Markering V-hals op halsboord

Pin neckband to neckline.
The unfinished sides of the neckband align with the raw edge of the neckline.
Start pinning at center back towards the V-neck.

Halsboord bevestigen

Pin V-neck notch of neckband to V-neck notch of neckline.


Stitch from center back towards the V using a stretch stitch.

Finish exactly in the V-neck notch with your needle down.
Gently pull the neckband while stitching.


Leave your needle down, lift up presser foot and turn V-neck towards you.


Clip in the V-neck of your shirt until right before your needle.

Turn your piece again, lower your presser foot and stitch the rest of the neckband into place.


If necessary, finish the seam with your overlock.
You can also topstitch the V-neck at the outside of your shirt 2mm from the edge.

Finished!

Happy sewing!

Kind regards,
Isabel

Free sewing instructions: V-neck T-shirt

Related content you may be interested in

Comments of this post

0 Responses

Leave a Reply

Your email address will not be published.

Required fields are marked *

Dear BERNINA Blog readers,

if you want to publish pictures via the comment function, please log in to the blog first. Click here to sign in.

You haven't registered for the BERNINA blog yet? Click here to create your free account.

Thank you very much

Your BERNINA Blog Team